PM5670-2ETH active revision 3, article 1SAP151000R0378, is a high-memory AC500 V3 processor module with 160 MB memory. It provides two independent Ethernet TCP/IP interfaces together with RS-232/485 and CAN communication.

The module includes an integrated display and memory-card support and operates from 24 V DC. A compatible TB56xx-2ETH terminal base is required to complete the CPU assembly and determine the available communication-module slots.

Manufacturer	ABB
Product Family	AC500 V3
Model	PM5670-2ETH
Active Article Number	1SAP151000R0378
Hardware Revision	Revision 3
Memory	160 MB
Supply Voltage	24 V DC
Ethernet Interfaces	2 independent RJ45 TCP/IP interfaces
Serial Interface	1 RS-232/485
CAN Interface	1
Ethernet Functions	Modbus TCP, web server, IEC 60870-5-104 and selectable protocols
Typical Module Current	140 mA
Maximum Typical Current	950 mA with communication and I/O load
Display	Integrated
Memory Card	Supported
Required Terminal Base	TB56xx-2ETH family
Lifecycle	Revision 3 Active; revision 2 R0278 Classic

• Runs large AC500 V3 applications with 160 MB controller memory.
• Provides two independently configurable Ethernet interfaces rather than a simple two-port switch.
• Supports Modbus TCP, web-server functions, IEC 60870-5-104 and selectable Ethernet protocols.
• Adds one configurable RS-232/485 interface and one CAN interface.
• Uses an integrated display and memory card for operation and maintenance.
• Allows a TB5660-2ETH base with six communication-module slots for this PM567x R0378 processor generation.

• Requires a TB56xx-2ETH base: TB5600, TB5610, TB5620, TB5640 or the PM567x-compatible TB5660 configuration.
• Revision 3 R0378 requires Automation Builder 2.6.0 or later and CPU and boot firmware V3.6.x or later.
• Revision 3 cannot be operated with firmware below V3.6.0.
• Both Ethernet networks, serial parameters, CAN configuration and communication-module order must match the engineering project.
• Current consumption must be calculated for the selected base, communication modules and attached I/O.

• Use R0378 for current revision 3 planning; the older R0278 hardware is in the Classic lifecycle phase.
• Upgrade the Automation Builder project and firmware before exchanging an R0278 processor for R0378 hardware.
• Retain the TB56xx-2ETH model, installed communication modules, memory card and all interface configurations.
• Do not interchange PM565x and PM567x processors solely by appearance because memory and supported terminal-base capacity differ.
• Validate both Ethernet segments, serial and CAN links, I/O, protocols and application startup after commissioning.

Which article identifies active PM5670-2ETH revision 3?

The active revision 3 article is 1SAP151000R0378.

How much memory is included?

PM5670-2ETH provides 160 MB of controller memory.

Are its Ethernet ports an unmanaged switch pair?

No. They are two independent onboard Ethernet TCP/IP interfaces with separate configuration possibilities.

Can this processor use a six-slot terminal base?

The PM567x R0378 generation can be used with the documented TB5660-2ETH six-communication-slot base.

What software is required for revision 3?

Use Automation Builder 2.6.0 or later with CPU and boot firmware V3.6.x or later.

What is included in a revision exchange check?

Check the R0378 article, firmware, terminal base, communication modules, memory card, two Ethernet networks, serial, CAN and the complete application.