LEGACY 7200 MEASUREMENT CHAIN · COMPLETE LABEL CONTROL
Bently Nevada 21500-00-28-10-02 7200 Series Proximity Probe
A legacy proximity-probe identity that must remain paired with its installed extension cable, Proximitor sensor and system-length record.
Overview
21500-00-28-10-02 is a legacy Bently Nevada proximity-probe ordering identity associated with the 7200 measurement-system generation. The full submitted code is retained because public manufacturer literature does not separately decode every suffix position.
Bently Nevada proximity systems operate as calibrated chains comprising the probe and integral cable, a matching extension cable and a compatible Proximitor sensor. A replacement decision therefore begins with all three labels, the documented total electrical length and the installed monitor-channel record.
Specifications
Features
Calibrated-system dependency
Probe behavior is established with the matching cable and Proximitor sensor rather than by the probe body alone.
Non-contact measurement
The eddy-current chain measures relative motion or position without mechanical contact with the observed target.
Legacy identity discipline
The complete order string remains visible so an undocumented suffix assumption cannot enter the spare record.
Chain-level troubleshooting
Static gap, cable continuity, connector condition and monitor response are assessed together.
Applications
Legacy machinery protection
Maintaining a documented 7200 proximity chain already installed on rotating equipment.
Relative motion measurement
Observing shaft-to-bearing-housing displacement where the original system design remains approved.
Controlled spare qualification
Comparing an offered probe only after the full installed chain and mechanical fit have been recorded.
Lifecycle
Capture
Photograph the exact probe, extension-cable and Proximitor labels and record the rack channel before disconnection.
Compare
Match system length, connector arrangement, mounting geometry and calibration family with the approved service record.
Prove
Set the approved gap and document stable static voltage, waveform response, alarms and interlocks after installation.
FAQ
Q01
What evidence should accompany a 21500-00-28-10-02 enquiry?
+
Provide clear labels for the probe, extension cable and Proximitor sensor, plus the machine location, monitor channel and requested quantity.
Q02
Can another 21500 code replace 21500-00-28-10-02 because the base number matches?
+
No. Similar base numbers do not prove identical cable, connector, mechanical or calibration requirements.
Q03
Why is the companion Proximitor identity important for 21500-00-28-10-02?
+
The probe belongs to a calibrated measurement chain, so the sensor generation and total electrical length affect interchangeability.
Q04
How should an intermittent 21500-00-28-10-02 signal be investigated?
+
Record static gap voltage and inspect connectors, cable movement, continuity and monitor diagnostics before assigning the fault to the probe.
Q05
What closes a 21500-00-28-10-02 replacement record?
+
Retain the delivered label, final gap, waveform check, alarm response and the approved chain-component list.
About IndustryParts
https://www.industryparts.com/Exact identity before quotation
IndustryParts prepares 21500-00-28-10-02 enquiries around the complete manufacturer label, requested quantity and destination. For controlled replacements, include the host-system record, field photographs and configuration evidence that apply to this exact execution.
Send the complete 21500-00-28-10-02 label, requested quantity and destination.
