24710-080-01-00 is a legacy Bently Nevada extension cable used in the 7200-series 11 mm proximity transducer system. Its configured length and cable construction are part of the calibrated electrical path between the probe and the matching sensor.

A 3300 XL 11 mm component is not a one-piece substitution for this legacy cable. A migration from the 7200-series system requires replacement of every transducer-system component and review of the monitor configuration.

• Extends the legacy 11 mm probe connection to its matched proximity sensor without changing the intended total system length.
• Provides mechanical protection around the cable for an installed rotating-machinery measurement loop.
• Maintains the shielded signal path used for vibration, position or phase-reference measurements.

• Photograph the probe, cable and sensor labels before disconnecting the existing channel.
• Keep the connectors clean and dry, avoid sharp bends, and prevent unsupported cable weight at the terminations.
• Do not shorten, splice or add an unmatched coaxial section to the calibrated loop.
• After reconnection, verify continuity, shield condition, stable gap voltage, polarity and monitor scaling.

• Record the complete legacy loop as one serviceable measurement chain rather than three interchangeable generic parts.
• If modernization is required, plan the probe, extension cable, Proximitor Sensor and monitor configuration as one project.
• Retain accepted baseline readings so post-maintenance signal quality can be compared before machine release.