330104-02-09-10-01-00 is a metric 3300 XL 8 mm proximity probe with armor. The ordering code defines 20 mm unthreaded length, 90 mm overall case, 1.0 m total probe length, standard cable, a ClickLoc connector with protector and no agency approvals.

The armored lead distinguishes the 330104 family from the non-armored 330103 probe. The probe remains electrically part of a matched 3300 XL 8 mm system and must be paired with the correct extension cable and Proximitor Sensor total length.

• Measures non-contact shaft vibration or position within a compatible 8 mm transducer chain.
• Uses armor to protect most of the lead in mechanically exposed routing.
• Provides a protected miniature coaxial connection for the extension cable.
• Fits M10 × 1 mounting hardware while retaining a defined unthreaded tip-side section.
• Supports standard 8 mm system response when target, gap and companion components meet the documented conditions.

• Check clearance for the armor ferrule, connector protector and minimum cable bend at the mounting bracket.
• Verify the 20 mm unthreaded section does not reduce required thread engagement or put nearby metal within side-view clearance.
• Choose the extension cable that completes the installed Proximitor Sensor length with the 1 m lead.
• Do not assign hazardous-area approval to the option 00 probe.
• Set gap and compare slow-roll and operating response after installation.

• Metric probe brackets requiring protected lead routing.
• Radial vibration and axial-position measurements on fluid-film bearing machines.
• Replacement of the exact armored 90 mm case execution in a standard-area installation.