Extends the probe connection to the matching Proximitor sensor while preserving calibrated system length.
Product Identification
330130-070-01-00 is a Bently Nevada 3300 XL standard extension cable.
The 070 length code specifies 7.0 m (22.9 ft), the 01 option specifies armored cable, and the 00 option indicates approvals are not required.
Extension-cable length and probe length must equal the total system length required by the matching Proximitor sensor.
Engineering Data
| Manufacturer | Bently Nevada |
|---|---|
| Exact ordering number | 330130-070-01-00 |
| Cable family | 3300 XL standard extension cable |
| Length code 070 | 7.0 m (22.9 ft) |
| Armor code 01 | Armored cable |
| Approval code 00 | Approvals not required |
| Armor outer jacket | FEP for standard probe cable armor |
| System rule | Probe length plus extension-cable length must equal the Proximitor total system length |
| Manufacturer datasheet | 3300 5 mm Transducer System, document 172036, revision T |
Functions
Provides mechanical protection through the armored cable execution.
Keeps the 7.0 m cable length visible in the ordering identity.
Uses the standard 3300 XL connector interface for the stated transducer family.
Applications
- Use only in a documented compatible 3300 XL transducer chain.
- Confirm that probe plus extension cable equals the required total system length.
- Route the armored cable without excessive bend, crushing, heat exposure or connector strain.
- Use the 00 execution only where product approvals are not required by the site classification.
Lifecycle
- Store capped and protected from moisture, contamination and connector impact.
- Record insulation, continuity and connector condition during planned maintenance.
- Replace damaged cable as an exact length and option rather than shortening or field-splicing the calibrated chain.
- Verify gap voltage and full channel response after any cable replacement.
About IndustryParts
https://www.industryparts.com/Cable supply stays tied to calibrated system length
IndustryParts prepares 330130-070-01-00 enquiries with the 7.0 m length, armored execution and complete probe-to-Proximitor chain recorded.
- 7.0 m length retained
- Armor and approval codes checked
- Complete system length requested
FAQ
Q01
Can a different extension-cable length be used if the connectors fit?
Only if the probe and extension cable still equal the Proximitor system length specified for that channel.
Q02
What does the armored option change in handling?
The armor improves mechanical protection, but the cable must still be routed without crushing, tight bends or load at the connectors.
Q03
Should 330130-070-01-00 be megger tested?
Use only test methods and voltages approved for the proximity system; inappropriate insulation testing can damage connected electronics.
Q04
What evidence helps distinguish 330130-070-01-00 from a CN suffix cable?
Provide clear photographs of both end labels and the full suffix; regional or approval-related suffixes must not be assumed equivalent.
Q05
What commissioning record is useful after replacement?
Document total system length, connector condition, gap voltage, monitor reading and the result of the channel functional test.
