8 CURRENT OUTPUTS · 13-BIT CONVERSION · VERSAMAX
Emerson IC200ALG326 VersaMax 8-Channel Current Analog Output Module
An eight-channel current-output module for commanding documented analog field loops from a VersaMax station.
Product Identification
IC200ALG326 is the eight-channel current analog output module listed in Emerson's VersaMax modular I/O catalog. It provides 13-bit output conversion for configured current loops.
Unlike the IC200ALG240 input module, IC200ALG326 drives field outputs. Safe-state planning, loop power, connected load and commanded scaling must therefore be captured before the module is disturbed.
Engineering Data
Functions
Eight current commands
Provides eight analog current-output paths in one VersaMax module.
Thirteen-bit conversion
Translates controller commands into the documented output resolution.
Project-defined behavior
Range, scaling and fault behavior remain controlled by the approved I/O configuration.
Carrier-based replacement
The module interface and field termination depend on the installed VersaMax carrier.
About IndustryParts
https://www.industryparts.com/Exact identity before quotation
IndustryParts prepares IC200ALG326 enquiries around the complete manufacturer label, requested quantity and destination. For controlled replacements, include the host-system record, field photographs and configuration evidence that apply to this exact execution.
Applications
Valve positioning
Commanding compatible current-driven positioners through approved loop designs.
Drive and actuator references
Providing current references where the receiving equipment and scaling are documented.
Loop-by-loop restoration
Returning a VersaMax station to service after controlled output proving.
Lifecycle
Prepare
Archive command scaling and place all eight possible loops in a defined safe condition.
Connect
Match the carrier and verify loop power, polarity and connected load for each used point.
Stroke
Command controlled values, measure loop current and confirm the final element before automatic operation.
FAQ
What should be documented before removing IC200ALG326?
Record each output range, scaling, safe state, field-power source, load resistance, carrier and complete label.
Can IC200ALG326 replace an IC200ALG240?
No. IC200ALG326 is an eight-channel current output module; IC200ALG240 is an isolated analog input module.
How should a weak IC200ALG326 output be investigated?
Compare commanded and measured current, then check loop supply, polarity, load resistance, wiring and channel diagnostics.
May the connected process remain automatic during a IC200ALG326 exchange?
Only if the approved operating procedure explicitly provides a safe method; otherwise place each affected loop in its defined manual or safe condition.
Which acceptance evidence is appropriate for IC200ALG326?
Record commanded current, measured current, controller value and final-element response at approved test points for every active channel.
Send the complete IC200ALG326 label, requested quantity and destination.
