Executes the VersaMax control application with configurable memory.
Product Identification
IC200CPUE05-EG is the EG revision of the Emerson VersaMax IC200CPUE05 controller with embedded Ethernet interfaces.
Emerson specifies RS-232, RS-485 and 10 Mbps Ethernet communications, system flash and battery-backed RAM for the base CPUE05 controller.
The EG suffix remains on the enquiry, spare record and acceptance test even when base-catalog specifications are used.
Engineering Data
ManufacturerEmerson / legacy GE Fanuc
Exact model and revisionIC200CPUE05-EG
Base catalog numberIC200CPUE05
PlatformVersaMax
Embedded communicationsRS-232, RS-485, Ethernet
Ethernet interfaceRJ-45 UTP, 10 Mbps half- or full-duplex
Configurable memory64 Kbytes maximum
Program storageSystem flash and battery-backed RAM
Floating pointSupported
Typical Boolean execution0.8 ms/K
Power demand220 mA at 5 V; 570 mA at 3.3 V
Dimensions126 × 128 × 69.1 mm
SRTP server connections8
Configuration-based EGD exchanges32
RevisionEG
Functions
Provides embedded serial and Ethernet communication paths.
Supports SRTP, configured EGD exchanges and network time synchronization features documented by Emerson.
Keeps the EG hardware revision traceable during controller replacement.
Applications
- Standalone VersaMax machine and process control.
- Ethernet-connected control using documented SRTP or EGD architectures.
- Legacy controller replacement where the CPU project and network settings are available.
- Maintenance requiring preservation of serial-port configuration and Ethernet identity.
Lifecycle
- Back up the complete project, hardware configuration and network settings.
- Record the EG label, battery state, serial port modes and connected devices.
- Confirm programming-software and firmware compatibility before transfer.
- Test I/O, communications, clocks, alarms and safe restart behavior after exchange.
About IndustryParts
https://www.industryparts.com/CPU revision, project and network identity stay together
IndustryParts reviews IC200CPUE05-EG with its firmware, project archive and every used communication path.
- EG suffix retained
- Project backup requested
- Ports and network recorded
FAQ
Q01What evidence should accompany an IC200CPUE05-EG enquiry?
Send the full CPU label, rack and power models, firmware, project-software release, network settings, serial-port use and required quantity.
Q02Can IC200CPUE05-EG be replaced using only an Ethernet address?
No. The CPU project, firmware, hardware configuration, memory content, serial settings and EG revision must also be controlled.
Q03Can another IC200CPUE05 suffix replace IC200CPUE05-EG automatically?
Do not assume interchangeability. Compare Emerson revision information, firmware support and the installed project.
Q04What should be checked before powering a replacement IC200CPUE05-EG?
Confirm carrier seating, power budget, battery condition, project compatibility and all network and serial connections.
Q05What proves IC200CPUE05-EG is ready for service?
Confirm the EG identity, clean diagnostics, correct program execution, stable I/O, Ethernet and serial communications, and an approved restart test.
