Emerson IC694MDL742B PACSystems RX3i 16-Point 12/24 V DC Positive-Logic Output Module
A sixteen-point positive-logic DC output module with electronic short-circuit protection and the B revision retained.
Product Identification
IC694MDL742B is the B hardware revision of the Emerson PACSystems RX3i IC694MDL742 discrete output module. The base module provides sixteen 12/24 V DC positive-logic outputs rated at 1 A with electronic short-circuit protection.
The B revision, terminal assignment, group power and field-load schedule must remain together. Adjacent IC694MDL74x modules differ in polarity, output current and protective behavior, so selection by family number alone is insufficient.
The B revision preserves the installed hardware baseline for this protected sixteen-point positive-logic output module.
Engineering Data
- Product family
- PACSystems RX3i I/O
- Base catalog number
- IC694MDL742
- Exact revision
- B
- Output points
- 16
- Output voltage
- 12/24 V DC
- Output current rating
- 1 A
- Logic
- Positive
- Protection
- Electronic short-circuit protection (ESCP)
- Installation
- RX3i rack I/O position
- Selection record
- Terminal wiring, group supply and load schedule
Functions
Switch positive-logic field loads
Controls sixteen documented DC loads from the RX3i I/O system.
Protect output groups
Electronic short-circuit protection supports fault containment within the published design.
Report controller state
Provides point status and module diagnostics through the rack I/O architecture.
Applications
Solenoids and relays
Use where field voltage, steady current and inrush remain within the approved output design.
Panel discrete control
Maintain group supply, common and protective-device coordination in the cabinet record.
Revision-controlled maintenance
Match the B label and project hardware configuration before exchange.
Lifecycle
Record
Capture IC694MDL742B, rack slot, terminal map, group supplies and every connected load.
Review
Check inrush, suppression, duty cycle and protective-device coordination for all outputs.
Exchange
Isolate field energy and transfer conductors position-for-position under the approved procedure.
Prove
Command every used point and verify load response, fault indication and safe-state behavior.
About IndustryParts
https://www.industryparts.com/Controlled handling for IC694MDL742B
IndustryParts keeps the submitted IC694MDL742B identity, requested quantity and installed-system evidence together so a proposed supply can be checked before dispatch.
- Suffix and MOD identity kept visible
- Mating hardware recorded before supply
- Acceptance evidence linked to the order
FAQ
What distinguishes IC694MDL742B from IC694MDL741?
The MDL742 base is a 1 A positive-logic module with electronic short-circuit protection; nearby modules have different polarity or ratings.
What should accompany a IC694MDL742B enquiry?
Provide the B label, rack slot, terminal schedule, group supply and load current/inrush information.
Does ESCP eliminate the need for circuit review on IC694MDL742B?
No. Field protection, wiring capacity, suppression and load behavior still need engineering review.
Can the B revision be ignored when selecting a spare?
No. Retain it and verify the project and installed hardware baseline before substitution.
What proves IC694MDL742B is ready after replacement?
Document correct module recognition and successful operation and diagnostics for each active output.
