Emerson IC695PNS001 PACSystems RX3i PROFINET Scanner
A PROFINET Scanner that serves as the head end of a remote RX3i Universal Backplane and supports line, star and MRP ring topologies.
Product Profile
Emerson IC695PNS001 is a pacsystems rx3i profinet scanner identified by the complete submitted ordering string. Its suffixes and revision fields remain part of the supply identity.
Selection of IC695PNS001 should be based on the installed label, host-system record and the verified interface details below; neighboring family numbers are not treated as interchangeable.
Technical Data
System Role
The scanner presents configured RX3i I/O from a remote Universal Backplane to one or more PROFINET I/O controllers.
Four switched ports allow copper and approved SFP media to be arranged for line, star or ring networks.
MRP supports documented ring recovery when the installed roles and topology are configured correctly.
The SD card can preserve and transfer the PROFINET Device Name during a controlled replacement.
Compatibility & Service
- Export the PROFINET controller project and record Device Name, IP data, slot configuration and topology.
- Verify every configured RX3i module is supported behind IC695PNS001 and do not plan extension racks.
- Transfer the Device Name by the approved controller or SD-card method and confirm the exact station identity.
- Test all I/O, network-loss fail states, MRP recovery, diagnostics and controller ownership.
Applications
- Remote RX3i I/O station connected to a compatible PROFINET controller.
- MRP ring or line topology with approved copper and SFP interfaces.
- Scanner replacement where Device Name, module configuration and fail-state behavior are documented.
FAQ
Q01Can IC695PNS001 control RX3i extension racks?+
No. IC695PNS001 is the head end of one remote Universal Backplane; extension racks behind the scanner are not supported.
Q02Why is the Device Name important when replacing IC695PNS001?+
PROFINET station recognition depends on it. Preserve the assigned Device Name through the approved controller or SD-card transfer procedure.
Q03Can any SFP be installed in IC695PNS001?+
No. Use only media modules approved for the scanner and verify fiber type, speed, connector and network design.
Q04What should be reviewed before placing IC695PNS001 in an MRP ring?+
Confirm manager and client roles, port assignments, cable path, recovery requirements and the approved PROFINET controller configuration.
Q05What proves IC695PNS001 is fully restored?+
The controller must own the correct station, all configured modules must exchange valid I/O, fail states must operate correctly and MRP recovery and diagnostics must pass.
