Emerson PR6424/010-100 16 mm Eddy Current Sensor
A 16 mm eddy current sensor configured with M18 × 1.5 thread, armored cable and a 4 m lead ending in LEMO termination.
Product Profile
PR6424/010-100
A 16 mm eddy current sensor configured with M18 × 1.5 thread, armored cable and a 4 m lead ending in LEMO termination.
Emerson PR6424/010-100 is a PR6424 16 mm eddy current sensor for non-contact measurement of shaft displacement, position, eccentricity and speed/key targets in critical rotating machinery.
The exact suffix decodes the mechanical and cable execution: M18 × 1.5 sleeve thread, armored cable, 40 mm sleeve code, no adaptor plug, 4 m total cable and a LEMO cable end.
Emerson treats the sensor, cable and matching converter as a calibrated measurement chain. The target material, converter identity and installed gap must therefore remain in the service record.
Technical Data
System Role
Record the complete chain
Capture PR6424/010-100, converter reference, channel setup, target material, bracket and cold-gap measurement.
Protect the armored route
Maintain bend radius, connector cleanliness, cable restraint and separation from interference sources.
Verify the measurement
Check gap voltage, direction, range, alarm behavior and machine protection response under the approved procedure.
Compatibility
Non-contact shaft measurement
The probe observes a ferromagnetic target without mechanical contact.
Encoded mechanical build
Thread, armor, sleeve length, cable length and termination are all fixed by the complete suffix.
API 670 measurement characteristics
Emerson publishes the temperature-error statement for API 670 compliant use.
Calibrated chain requirement
Sensor, extension connection where applicable and converter must match the approved measuring chain.
Applications
Radial shaft vibration
Measuring shaft motion on turbines, compressors, pumps and fans.
Axial position monitoring
Tracking controlled shaft position with the documented target geometry and installed gap.
Speed or key reference
Using the eddy-current response with the converter and monitoring channel designed for the key signal.
About IndustryParts
https://www.industryparts.com/Application evidence stays with PR6424/010-100
IndustryParts keeps the requested model, quantity, label evidence and delivery record together so the proposed supply can be reviewed against the real installed application before dispatch.
FAQ
Q01
What must accompany a PR6424/010-100 sensor enquiry?
+
Provide the complete probe label, converter model and serial data, target material, shaft diameter, bracket, measured gap and cable-route photographs.
Q02
Which thread and cable construction belong to PR6424/010-100?
+
The ordering code selects an M18 × 1.5 thread, armored cable, 4 m total cable and LEMO termination.
Q03
Can PR6424/010-100 be evaluated without its converter?
+
Not as a complete measurement chain. Emerson supplies PR642x sensors for use with the matching calibrated CON0x1 converter arrangement.
Q04
What target geometry is published for PR6424/010-100?
+
The PR6424 data specifies ferromagnetic 42CrMo4 reference material and a shaft diameter of at least 80 mm.
Q05
What should be retained after installing PR6424/010-100?
+
Keep the gap-voltage result, mechanical clearance, cable inspection, channel scaling, alarm checks and final machinery-protection test record.
