Siemens 6ES7522-5EH00-0AB0 SIMATIC S7-1500 DQ 16x24–48 V UC/125 V DC/0.5 A ST Module
A standard S7-1500 output module with sixteen individually grouped universal-voltage channels for approved sourcing or sinking circuits.
Product Identification
6ES7522-5EH00-0AB0 is the SIMATIC S7-1500 DQ 16x24–48 V UC/125 V DC/0.5 A ST output module. Its sixteen channels are arranged as sixteen individual groups.
Depending on the documented DC wiring, the module supports sourcing or sinking operation. Diagnostics and substitute values are supported; the front connector is ordered separately and published derating rules must be applied.
Universal-voltage capability does not remove the need to match polarity, load type, group supply and derating for each 6ES7522-5EH00-0AB0 channel.
Engineering Data
- Module designation
- DQ 16x24–48 V UC/125 V DC/0.5 A ST
- Output count
- 16
- Channel grouping
- 16 groups of 1
- Output arrangement
- Sourcing or sinking for DC, according to wiring
- Rated current per channel
- 0.5 A
- Maximum current per group
- 0.5 A
- Diagnostics
- Supported
- Substitute values
- Supported
- Derating
- Observe published load and temperature derating
- Included hardware
- U-connector
- Front connector
- Ordered separately
- Dimensions
- 35 × 147 × 129 mm
Functions
Drive universal-voltage loads
The channel design covers the published AC/DC output range when wired as specified.
Separate field circuits
Each output forms its own group for controlled circuit design.
Report supported faults
Diagnostics expose configured module and field conditions.
Hold defined fault behavior
Substitute values support planned controller-stop or communication responses.
Applications
Higher-voltage solenoids
Used where the approved actuator circuit falls within the published UC/DC range.
Mixed polarity DC design
Sourcing or sinking operation is selected through the documented circuit arrangement.
Individually protected outputs
One-channel groups support deliberate field protection and isolation planning.
Lifecycle
Record every circuit
Capture voltage, polarity, load, protection and terminal assignment for all used channels.
Apply derating
Check ambient temperature and simultaneous current against Siemens limits.
Prove safe operation
Test outputs, substitute values, diagnostics and the approved shutdown path.
About IndustryParts
https://www.industryparts.com/Controlled handling for 6ES7522-5EH00-0AB0
IndustryParts keeps the submitted 6ES7522-5EH00-0AB0 identity, requested quantity and installed-system evidence together so a proposed supply can be checked before dispatch.
- Suffix and MOD identity kept visible
- Mating hardware recorded before supply
- Acceptance evidence linked to the order
FAQ
Can 6ES7522-5EH00-0AB0 be wired as both sourcing and sinking?
For DC circuits, Siemens identifies sourcing or sinking operation according to the documented wiring; the exact circuit must be retained.
Is the front connector supplied with 6ES7522-5EH00-0AB0?
No. The U-connector is included, but the front connector is ordered separately.
Why is derating important for 6ES7522-5EH00-0AB0?
Permitted simultaneous load depends on operating conditions, so the published derating limits must be checked.
What information should accompany a 6ES7522-5EH00-0AB0 request?
Provide voltage, polarity, load type, channel schedule, connector identity and the TIA Portal hardware record.
How should 6ES7522-5EH00-0AB0 be validated after service?
Command every used output and verify correct polarity, load response, diagnostics, substitute behavior and interlocks.
