Siemens 6SE7041-8GK85-0HA0 MASTERDRIVES PER3 Rectifier Interface Module
PER3 rectifier interface for design H and K MASTERDRIVES infeed and regenerative-feedback supply units.
ManufacturerSiemensModel6SE7041-8GK85-0HA0Product TypeRectifier interface module PER3 for MASTERDRIVES infeed and regenerative-feedback units
01Product Identification
Siemens 6SE7041-8GK85-0HA0 is the PER3 rectifier interface module for SIMOVERT MASTERDRIVES infeed and regenerative-feedback supply units in designs H and K. Siemens specifies its use with 500 to 575 V AC or 660 to 690 V AC three-phase networks at 50 or 60 Hz. It is a configuration-specific interface module, so the supply-unit design, voltage class, wiring and complete article number must match the installed system.
Configuration ControlVerify the full article number, nameplate, electrical design, interfaces, software, wiring and lifecycle requirement before ordering.
02Engineering Data
| Manufacturer | Siemens |
|---|---|
| Article Number | 6SE7041-8GK85-0HA0 |
| Product Designation | Rectifier interface module PER3 |
| Product Family | SIMOVERT MASTERDRIVES |
| Applicable Equipment | Infeed and regenerative-feedback supply units |
| Supported Designs | H and K |
| Voltage Class 1 | 500 to 575 V AC, 3-phase, 50/60 Hz |
| Voltage Class 2 | 660 to 690 V AC, 3-phase, 50/60 Hz |
| Primary Role | Rectifier interface within the supply-unit assembly |
| Lifecycle | Phased out / discontinued |
03Functions
Operational Functions
- Provides the PER3 interface function in compatible MASTERDRIVES supply-unit assemblies.
- Supports the documented design H and design K equipment configurations.
- Covers both 500 to 575 V and 660 to 690 V three-phase voltage classes.
- Integrates into infeed and regenerative-feedback systems rather than operating as a standalone drive.
- Uses the exact Siemens article number to define the interface revision and voltage application.
- Supports maintenance of installed MASTERDRIVES line-supply architectures.
Identification
- Manufacturer: Siemens
- Model: 6SE7041-8GK85-0HA0
- Product Type: Rectifier interface module PER3 for MASTERDRIVES infeed and regenerative-feedback units
- Status: Discontinued product
04Applications
Use Cases
- Service replacement in design H or K MASTERDRIVES infeed units.
- Maintenance of regenerative-feedback supply assemblies in the listed voltage classes.
- Legacy drive-line cabinets requiring the exact PER3 rectifier interface article.
- Planned refurbishment where the supply-unit design and wiring are documented.
- Spare-parts control for phased-out MASTERDRIVES power-supply systems.
Compatibility Boundary
- Confirm that the host equipment is an infeed or regenerative-feedback supply unit in design H or K.
- Match the actual network voltage to the documented 500 to 575 V or 660 to 690 V class.
- Compare the complete article number, interface connectors, wiring and module revision.
- Follow high-voltage isolation, DC-link discharge and electrostatic-discharge procedures.
- Inspect the host supply unit for related faults before replacing the interface module.
- Do not use the module as a substitute for other PER revisions without Siemens documentation.
05Lifecycle
- Siemens identifies the article as phased out or discontinued.
- Availability may depend on specific-order or customer-managed spare-part channels.
- Keep the host-unit article, design size, voltage class and wiring records with the spare.
- No direct replacement is asserted without an official system comparison.
- After installation, verify supply-unit startup, rectifier control, regenerative operation, diagnostics and all protection functions.
